Serinus 40 User Manual 2.2
Figure 78 – Attach rear rack mount adaptors to slide
7. Install rack mount ears on the front of the instrument using two M4 x 10 screws on each side
(refer to Section 2.2).
Figure 79 – Rack mount ears fitted to analyser
8. Now carefully insert the instrument into the rack by fitting the instrument slides into the
mounted rails. Ensure the rack slide locks engage on each side (you will hear a click from both
sides).
Note: Ensure both sides of the inner slide are attached to the outer slides before pushing into the
rack fully.
To Next Page
Loading...
