4.5 Using Airodis Software to Download Data from a Serinus Gas Analyser
4.5.1 Installation
Configure the Serinus Logging Interval
In order to download logged data from the Serinus, you will need to define the data logging interval.
Navigate to Main Menu Communications Menu Data Logging Menu
Figure 12 – Configure Serinus logging interval
Set the Data Log Interval to the desired value.
4.5.2 Connecting the Serinus to your PC
The Serinus Gas Analyser can communicate with a PC using RS-232 (Serial), TCP (Network), Bluetooth
or USB. Serial, Bluetooth and network communications do not require additional drivers. If you wish
to connect using a USB cable, the driver must be installed.
4.5.2.1 Connecting over USB
If you wish to connect using USB, you will need to first install the Serinus USB driver.
Power on the Serinus and connect it to your PC with a USB cable. You should receive a prompt if the
driver needs to be installed. If not, open Device Manager (Under “System” in Control Panel), find the
device and select “Update Driver Software”.
Figure 13 – Installing driver software
To Next Page
Loading...
