Serinus 40 User Manual 2.2
Figure 18 – Serial communications menu
Determine which RS232 Port you are physically connecting with. You can use either; however,
multidrop is only supported on RS232 #2.
Set the appropriate baud rate (in most situations, fastest is best).
Ensure that the protocol is set to Advanced.
If you are running Airodis in a multidrop configuration (multiple instruments on a single COM port),
ensure that the multidrop ID is unique for each instrument on the chain.
4.5.2.3 Connecting over Network (TCP / IP)
From the Serinus menu, navigate to Main Menu Communications Menu Network Adaptor
Menu.
Figure 19 – Network adaptor menu
1. Ensure that the protocol is set to Advanced.
2. Assign a unique static IP address to the instrument.
3. Reboot the Serinus by cycling the power.
4.5.3 Installing Airodis
You can download data from the Serinus using either a full retail (paid) version of Airodis or with the
demo version which is included on the green Ecotech Resources USB stick. The demo version has
limited functionality, but will allow you to download and export data from a Serinus (up to 3
instruments). If you do not already have Airodis, this can be obtained from Ecotech:
http://www.airodis.com.au/
The installer is straightforward – ensure you install the correct version for your operating system. If
you are running 64-bit windows, install the 64-bit (x64) version. Otherwise, install the 32-bit (x32)
version.
To Next Page
Loading...
