Edwards iDT-002

Display Unit iDT-002
MT-91E-A01-B
Page 22
OPERATION
4
4.4 Operation mode of display unit
The display unit iDT-002 has five operation modes as shown in Table 5 .
Any operation modes are effective to operate the STP pump at in every port regardless of the input
operation port setting.
Mode
Function
1
Operation Mode
(see Section 4.5)
Operation state, warning, and failure check of the
STP pump
2
Confirmation Mode
(see Section 4.6)
Status monitor and parameter check of the STP
pump
3
Parameter Set Mode
(see Section 4.7)
Parameter setting of the STP pump
4
Manual Operation Mode
(see Section 4.8)
TMS output operation
5
Input Operation Port Set
Mode
(see Section 4.9)
Parameter change of the input operation ports
Table 5 - iDT-002 operation mode
Note: The STP pump can be operated with any operation mode. (see Section 4.3)