Edwards iDT-002

Display Unit iDT-002
MT-91E-A01-B
Page 30
OPERATION
4
F
F1
F2
F3
F4
F5
Speed Set Point
xxxxx rpm
2nd Speed Set
xxxxx rpm
TMS Set Point
xxx °C
Motor Temp
xxx °C
Ctrl Temp
xxx °C
G
G1
G2
G3
H
Operation Port
iX X2:I/O Remote
TMS Function
DISABLE
Vent Valve Opt.
DISABLE
G8
G4
G7
2nd Speed Option
DISABLE
Warn. Pump Time
DISABLE
Warn. Overload
DISABLE
Err Rec. 1/ n
(failure message)
Err Rec. n/ n
(failure message)
Err Rec. */ n
(detected time)
………
F6
Motor Current
xxx.x %
G5
G6
Warn. 1st Damage
ENABLE
Warn. Imbalance
ENABLE
E
UP
DOWN
UP
DOWN
SELECT
SELECT
ENTER
SELECT
I
UP
DOWN
E.
From Individual
information
F1.
Rated speed setting
G1.
Input operation port
setting
F.
Set value/measured
value
F2.
Second speed setting
G2.
TMS function setting
(optional accessory)
G.
Function setting
F3.
TMS temperature
setting
G3.
Vent Valve Option Setting
H.
Error record
F4.
Pump motor
temperature setting
G4.
Second speed option
setting
I.
Return to operation
mode
F5.
Control unit
temperature
measurement
G5.
Warning function setting
(bearing damage)
F6.
Motor current
measurement
G6.
Warning function setting
(imbalance)
G7.
Warning function setting
(pump runtime)
G8.
Warning function setting
(pump overload)
Figure 15 - Confirmation mode operation method (2/2)