Edwards iDT-002

Display Unit iDT-002
MT-91E-A01-B
Page 38
OPERATION
4
4.7.14 Date / time setting
That can set the present date/time in the built-in clock.
4.7.15 Factory setting of the STP pump
The factory settings of the STP pumps are shown in Table 11. The active functions are depending on
the STP pump models. (see Table 9)
Items
Factory setting
Remarks
Input operation port
I/O Remote
Depending on the connecting STP pump model
Rotational speed
Rated speed
Depending on the connecting STP pump model
TMS function
DISABLE
ENABLE with TMS (optional accessory)
TMS temperature setting
Maximum setting
value
Depending on the connecting STP pump model
Second speed option setting
DISABLE
Second speed setting
50% of Rated
speed
Depending on the connecting STP pump model
Second Damage Limit function
ENABLE
Vent Valve Option Setting
DISABLE
Vent Valve Open Speed Setting
50% of Rated
speed
Depending on the connecting STP pump model
Vent Valve Operating Time Setting
60 sec.
Warning function
Warn. 1st Damage
ENABLE
Warn. Imbalance
ENABLE
Warn. Pump Time
DISABLE
Pump RunTime Set
0 hour
When the setting value is 0, the WARNING
function is invalid.
Warn. Overload
DISABLE
Current Rate Set
100.0 %
Speed Rate Set
0.0 %
Serial communication timeout
1 min.
Set "DISABLE" when the value is 0 min.
Serial port
Baud Rate
9,600 bps
(COM1)
Bit Length
8
Stop Bit
1
Parity
None
Driver Type
RS232/485
Single
RS485ID
1
Terminator
Not use
Profibus ID
0
Serial port
Baud Rate
9,600 bps
(COM2)
Bit Length
8
Stop Bit
1
Parity
None
Driver Type
RS485 Single
RS485ID
1
Terminator
Not use
Profibus ID
0
Table 11 - Factory setting of the STP pump