Edwards iDT-002

Display Unit iDT-002
MT-91E-A01-B
Page 33
OPERATION
4
4.7.1 Input operation port setting
The “Input operation port setting” can set the ports to operate STP pumps start, stop and alarm reset.
The STP pumps can be operated through the parallel ports (X2 REMOTE connectors) or two serial
ports (X3 COM1 connector and/or X4 COM2 connector) that the STP pumps have.
However, the ports that can set in this setting are different according to the STP pump models. Table
10 shows which port can be selected per the STP pumps.
Parameter
STP pump model
iX457
iXU457
series
iS1607
iS2207
series
iXA2206
iXA3306
iXA4506
iX3006
series
iXA3307
iXA4507
series
1.
Parallel port
X2 REMOTE
connector
X2 REMOTE
connector
X2 REMOTE
connector
X4 REMOTE
connector*
1
2.
Serial port COM1
X2 REMOTE
connector
X3 COM1
connector
X3 COM1
connector
NOT available
3.
Serial port COM2
NOT available
NOT available
X4 COM2
connector
X2 COM2
connector
Table 10 - Input operation port setting
Note: The operating state can be monitored with any port.
4.7.2 Rotational speed setting
The rotational speed can be changed in 500-rpm intervals in a NORMAL state.
2
The ranges that can be set differ depending on the connected STP pump model.
4.7.3 TMS function setting
That can set Enable/Disable the TMS function (optional accessory). When setting to ENABLE, the
TMS runs. Disable the function when the TMS unit is not equipped in the STP pump, or when the
TMS output is controlled in the “Manual Operation Mode”.
*
1
STP-iXA3307/iXA4507 with EtherCAT model series do not have X4 REMOTE connector.
*
2
The rotational speed can be changed up to the maximum rated speed with the STP pump which does not set the rotational
speed in 500-rpm intervals in NORMAL state.