4.9 Input operation port set mode
4.9.1 Input operation port setting
Refer to Section 4.7.1, “Input operation port setting”.
4.9.2 Setting procedure
Refer to Figure 24.
1. Press "ENTER" and "SELECT" switches simultaneously to enter the “Input operation port set
mode” while the “Operation Mode” is displayed. The current setting will be displayed on the LCD.
2. Press the "UP" switch to enter the next parameter, and press the "DOWN" switch to display the
previous one.
3. Press the "ENTER" switch to save setting the input operation port. The LCD displays "IN
PROGRESS," and then it returns to the “Operation Mode” automatically.
4. If the saving fails, "NOT OK/TIME OUT" is displayed, and then it will return to the input operation
port setting display after approximately 2 seconds. In this case, try to save it again.
5. Press the "SELECT" switch in the “Input operation port setting mode” and return to the
“Operation Mode”. In this case, the changed setting is not saved.
Note: If no switch is pressed for approximately 1 minute, the display will automatically revert to
Operation Mode. In this case, the setting is not changed.
Note: When the communication error is detected, the STP pump cannot enter the Input Operation
Port Set Mode. The STP pump will automatically return to the Operation Mode when the
communication error occurs in the state of the Input Operation Port Set Mode.
Note: When the data cannot be obtained, "no data" is displayed, and the parameter is not changed.
To Next Page
Loading...