Edwards iDT-002

Display Unit iDT-002
MT-91E-A01-B
Page ii
PAGE
ii
CONTENTS (CONTINUED)
Section Title Page
4.7 Parameter set mode 32
4.7.1 Input operation port setting 33
4.7.2 Rotational speed setting 33
4.7.3 TMS function setting 33
4.7.4 TMS temperature setting 34
4.7.5 Second speed option setting 34
4.7.6 Second speed setting 34
4.7.7 Second damage limit function setting 34
4.7.8 Vent Valve Option Setting (Air-cooling fan function) 34
4.7.9 Vent Valve Open Speed Setting 35
4.7.10 Vent Valve Operating Time Setting 35
4.7.11 Warning function setting 36
4.7.12 Serial communication timeout setting 37
4.7.13 Serial port COM1/COM2 setting 37
4.7.14 Date / time setting 38
4.7.15 Factory setting of the STP pump 38
4.7.16 Setting procedure 39
4.8 Manual operation setting 46
4.8.1 TMS function setting and vent valve function setting 46
4.8.2 Operating method 46
4.9 Input operation port set mode 48
4.9.1 Input operation port setting 48
4.9.2 Setting procedure 48
5 TROUBLESHOOTING 51
5.1 Specific error messages of the display unit iDT-002 51
5.2 "FAILURE" LED illuminates or "w" is displayed
in the upper left-hand corner of the LCD 52
5.3 Cleaning 52
5.4 Transport for repair or overhaul 52
6 STP-LINK 53
6.1 STP-Link 53
7 STORAGE AND DISPOSAL 55
7.1 Storage of the STP pump 55
7.2 Disposal 55