Edwards nEXT730 - Interface Cable; Nst2 PC Program; Auxiliary Connector; Auxiliary Extension Cable

B8J200880_E - Accessories
Page 126
Table 44 PRX purge restrictor
Item
Item Number
PRX10 purge restrictor
B58065001
14.8 Interface cable
An interface cable connects the nEXT pump to a PC. Serial commands are then used to
control and monitor the nEXT pump.
Table 45 Interface cable
Item
Item Number
nEXT Interface cable
B80000808
14.9 nST2 PC program
The nST2 PC program is PC-based software that can be used with the nEXT pump, either
via the serial interface or via the USB service port.
It can be used to control, monitor, configure and data log the nEXT pump, and also to
view service status, reset service intervals and upgrade the software embedded in the
motor controller.
This software is available for download from the Edwards upgrades website:
www.upgrades.edwardsvacuum.com
14.10 Auxiliary connector
Enables the use of accessories that do not come prewired with a mating plug. Cable
length is 1.5 m.
Table 46 Auxiliary connector
Item
Item Number
nEXT auxiliary connector
B8G200839
14.11 Auxiliary extension cable
The cable extends the distance of the accessory to the pump and benefits from a right
angled plug to accommodate installation where space is limited. Cable length is 0.2 m.