Edwards STP-iX455

STP-iX455/iXL455 Series Instruction Manual
7-1
Operation
7 Remote Input/Output Signal Connector
The remote input/output signal connector "X2 REMOTE" is used for input/output
remote signals of the parallel mode.
This connector is of D-Sub
1
type (25 pins, socket type).
The screw for connector is M2.6.
Figure 7.1 X2 REMOTE Pin Arrangement
◇ The connector (pin type) for remote connection is included. Procure control
equipment at your company.
◇ It is recommended to use the remote cable of the shield type grounding both
ends.
1
: D-Subminiature connector (Conforms to MIL–C–24308)
(25)
(13)
(12)
(2)
(1)
(24)
(15)
(14)