STP-iX455/iXL455 Series Instruction Manual
5
APPLIED STANDARDS
The STP pump conforms to the following directives and standards:
◇ Applied Directives
EC Machinery directive
EC Low voltage directive
EC Electromagnetic compatibility directive
◇ Applied Standards
EN1012-2
EN61010-1
EN61326 (class A)
EN55011 (class A)
UL61010-1 (Electrical Equipment for Measurement, Control, and Laboratory Use)
◇ Electromagnetic compatibility
This product is a class A product according to EN61326, and a group 1, class A
product according to EN 55011. This means that this product does not generate
and/or use intentionally radio-frequency energy, in the form of electromagnetic
radiation, inductive and/or capacitive coupling, for the treatment of material or
inspection / analysis purpose and that it is suitable for use in all establishments other
than domestic and those directly connected to a low voltage power supply network
which supplies buildings used for domestic purposes.
This product may have potential difficulties in ensuring electromagnetic compatibility in
other than industrial environments, due to conducted as well as radiated disturbances.
This product must not be used in residential areas because it may cause interference if
used in residential areas.
PRECAUTIONS
1) No part of this manual may be reproduced in any form by any means without prior
written permission from Edwards.
2) Edwards pursues a policy of continuing improvement in design and performance of this
product. The right is, therefore, reserved to vary specifications and design without
notice. Understand that the product you purchased and its contents including
specifications described in this manual may differ.
REQUEST
If you find inaccuracies or errors in this manual, advise distributor or the nearest Service
office.
To Next Page
Loading...
Need help?
General
