Edwards STP-iX455

STP-iX455/iXL455 Series Instruction Manual
7-3
Operation
Table 7.1 X2 REMOTE Input Signal Pins (2/2)
Pin Description
Pins for inputting the input operation port select signal.
When the pins between (24)–(13) are short-circuited, the
input operation port will be set to the parallel port
automatically, and the input operation via the serial port
is disabled.
When the pins between (24)–(13) are opened, a parallel
port or any of four serial ports from COM1 to COM4 can be
selected in the input operation port (see Section 7.1.1).
Pins for inputting the rotation INHIBIT enable signal.
The input pins are valid even when input operation port is
set to serial port.
When the pins between (24)–(25) are short-circuited, the
rotation INHIBIT signal input is enabled.
Pins for inputting the vent valve enable signal.
When the pins between (24)–(12) are short-circuited, the
vent valve connected to the connector X6 is controlled
according to the setting value during the deceleration
state. Refer to Section 8.1, "Vent Valve Output" for the
vent valve setting.
◇ COM is assigned on (1) pin and (24) pins. Both pins are connectable.
(1) (24) (13)
COM PORT SELECT IN
(1) (24) (12)
COM VALVE ENABLE IN
(1) (24) (25)
COM INHIBIT ENABLE IN