All work on this product (system design, installation, operation, setting, configuration, and
maintenance) must be carried out by qualified personnel. To reduce the risk of electric
shock, do not perform any servicing other than those specified in the operating instructions
unless qualified to do so.
1. Read all instructions before installing. For electrical work, follow all local and national
wiring standards, regulations, and these installation instructions.
2. Make sure the inverter is properly grounded. All wiring should be in accordance with the
National Electrical Code (NEC), ANSI/NFPA 70.
3. The inverter and system can inter-connect with the utility grid only if the utility provider
permits. Consult with the local AHJ (Authority Having Jurisdiction) before installing this
product for any additional regulations and requirements for the immediate area.
4. All warning labels and nameplates on the inverter should be clearly visible and must not be
removed or covered.
5. The installer should consider the safety of future users when choosing the inverter’s correct
position and location as specified in this manual.
6. Please keep children from touching or misusing the inverter and relevant systems.
7. Beware! The inverter and some parts of the system can be hot when in use, please do not
touch the inverter’s surface or most of the parts when they are operating. During operation,
only the LCD and buttons should be touched.
DISCLAIMER
EG4 reserves the right to make changes to the material herein at any time without notice.
Please refer to
www.eg4electronics.com
for the most updated version of our manuals/spec sheets.
WARNING! To reduce the risk of injury, read all instructions
To Next Page
Loading...
Need help?
General
