Operating manual - Fan CF-C Introduction
2004930 10.19/0.2 www.elektror.com 11 of 84
EN
- Installation personnel would make faulty electrical connection of the fan (electric motor).
-
The technical service personnel would forget tools or other items inside the fan. During start
up it is possible that tools or other objects are not noticed inside the fan.
The technical service personnel would perform activities on the fan and its components
when the fan is running.
Personnel would tamper with safety systems.
Personnel would remove the safety devices that separate the fan from people and start the
fan.
Personnel would fail to comply with the obligation to wear personal protective equipment.
- Personnel would use the console as an auxiliary ladder.
The above points only contain predictable uses in a way incompatible with the intended use,
the list may not be complete. Its content is based on the manufacturer's experience.
1.6 Necessary qualifications to operate the fan
The operating manual establishes qualifications for various areas of activity.
Cleaning personnel
The cleaning personnel was instructed by the user about the tasks assigned to him and
possible risks in the event of inadequate handling. This personnel carries out c
leaning of the
Electrical engineer
The electrical engineer, due to his professional qualifications, knowledge and experience as
well as knowledge of standards and provisions, is able to independently perform work on the
electrical installation and
identify risks and avoid them.
The electrical engineer is trained in the location of the place of work and knows the relevant
standards and regulations.
Maintenance engineer
The maintenance engineer, due to his professional qualifications, knowledge an
d experience
as well as knowledge of standards and provisions, is able to independently perform
mechanical work on the fan and identify risks and avoid them.
The maintenance engineer is trained in the location of the place of work and knows the
relevant standards and regulations.
Employee authorized to give instructions
The employee authorized to give instructions, due to the professional qualification and
authorization by the company, is authorized to give instructions to qualified personnel and is
obli
ged to perform control. The employee authorized to give instructions simultaneously
coordinates work and processes running in parallel.
Authorized person with additional qualifications for EX protection according to TRBS
1203
The authorized person with
additional qualifications in the scope of EX protection, due to his
professional qualifications, knowledge and experience as well as knowledge of standards and
provisions, is able to independently perform work in potentially explosive areas and in the area
of explosion protection components, and identify and avoid risks.
Information on assigning qualifications to activities at various stages of the machine's life
is available in the chapter "Activities and qualifications" for a specific stage of the dev
ice's
To Next Page
Loading...