Operating manual - Fan CF-C Operation of the fan
2004930 10.19/0.2 www.elektror.com 65 of 84
EN
8.8.5 Lubrication of the fan
Damage caused by the use of incorrect lubricants
The use of unsuitable lubricants and incorrect handling of these
materials may cause
damage to the fan.
Do not mix lubricants of different quality because their composition
is different and different additives are used for their production. This
principle applies primarily to lubricants based on mineral and
synthetic oils.
Always use the amount of lubricants given, as both excess and
shortage of these agents can degrade the functionality of the fan.
8.8.5.1 Special tools, equipment and materials
Products and materials which are assumed to be not a component of a typical workshop in an
industr
ial standard are considered special tools, devices and materials. At the stage of
"Maintenance" there is no need to use special tools, equipment and materials.
Table 20: Special tools, equipment and materials
Name Appearance Use Manufacture
r
press
Supplying lubrication points with a
lubricant
–
8.8.5.2 Lubricants
Only lubricants specified by the manufacturer should be used so as not to degrade perfect
accessibility of the fan. Specifications of lubricants are i
ncluded in the chapter "Lubrication
schedule" and assigned to lubrication points.
The bearings are filled with a suitable quantity of grease at the factory and are ready for
operation. The types of grease presented below are standard lubricants. If other lubricants are
to be used, they are listed in the "Addendum to the operating
manual
" or in the "Instructions for
the job".
Lubrication is carried out using a manual lubrication press, available commercially (see
Table
20: Special tools, equipment and materials).
8.8.5.3 Symbols in lubrication schedules
Table 21: Explanation of symbols in lubrication schedules
Check the
level
Fill Replace Lubricate with
oil
a grease
press
Lubricate wi
a brush
Shower
To Next Page
Loading...