Elektror CF Series - 1 Introduction; Important Information about the Operating Manual; Liability; Short Description of the Fan

Operating manual - Fan CF-C Introduction
2004930 10.19/0.2 www.elektror.com 9 of 84
EN
1 Introduction
1.1 Important information about the Operating Manual
The operating manual applies to C fan.
The operating manual is a separate part of the technical documentation and part of the
product.
The operating manual is a source of information for the fan user, allowing for safe and efficient
use of the fan.
Please read the operating manual ca
refully. Understanding of this operating manual is a
prerequisite for proper fan operation. You should always follow its recommendations and
information, especially in the area of security. Do not proceed according to the information
extracted from individ
ual chapters without including the manual as a whole.
The operating
manual contains references to other documents. You also need to follow the
content of these documents.
Some figures, included in the operating manual, are used to explain technical details
. The
colours of the presented elements may differ from the original.
The operating manual requires storage in a binder in a way that allows it to be accessed at all
times.
In the case of providing the digital manual and the need to prepare a printout for internal use, if
such action is not a copyright infringement, it is generally advisable to print in colour, as some
of the information contains full information only as a colour presentation.
1.2 Liability
Information on liability and warranty rights is included in the terms and conditions of the
contract for this project. The manufacturer excludes all liability for delays and damages
resulting from non-compliance with this operating manual.
The manufacturer is not responsible for errors in this operating manual. Liability for indirect
and direct damages related to the delivery or use of this operating manual is excluded to the
extent permitted by applicable law.
1.3 Short description of the fan
Fan with housing in which both bearings
are located (bearing block)
Fan with bearings in the form of a
pedestal bearing
The fan is a single-stage centrifugal fan, welded, used to
convey air, gases similar to air or gas mixtures.
The electric drive is carried out via the motor shaft, fan
shaft and clutch.
The fan shaft bearings were made in accordance with the
version
2 rolling bearings, grease lubricated, in housings
with pedestal bearings or
2 rolling bearings, grease
lubricated in one housing (bearing blocks)