Elektror CF Series - 12 Declaration of Incorporation According to Annex II 1 a; Declaration of Conformity According to EVPG § 4 Passage 1

Declaration of incorporation according to Annex II 1 A Operating manual - Fan CF-C
Declaration of conformity according to EVPG § 4 passage 1
84 of 84 www.elektror.com 2004930 10.19/0.2
EN
12 Declaration of incorporation according to Annex II 1 A
Declaration of conformity according to EVPG § 4 passage 1
The manufacturer
Elektror airsystems Sp. z.o.o
Leśna 38
41-506 Chorzów, Polen
Hereby declares that the product to which this declaration refers, meets the basic requirements of the
Machinery Directive (2006/42/EG) as set forth below.
Description of the incomplete machine:
CFL1, CFL2, CFM1, CFM2, CFH1, CFH2, CFH3, CFXH, CFXH1, CFXH2, CFLD, CFLD1,
CFMT, CFMT1, CFMT2, CFM1D, CFH1D
Description of the essential requirements of Machinery Directive (2006/42/EG), with which the
partially completed machine complies:
Machine directive (2006/42/EG): Annex I, Articles 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.5.1,
1.6.1, 1.7.1, 1.7.3.
The partially completed machine described here continues to fulfil the protective regulations of the
Low Voltage Directive (2014/35/EU) according to Annex I, No. 1.5.1 of the Machinery Directive. The
commissioning of the partially completed machine is not permitted until it has been verified that the
machine in which the partially completed machine is to be installed, complies with the provisions of
the Machinery Directive (2006/42/EG).
The following harmonized standards were applied:
DIN EN ISO 12100 2011 Safety of machinery – General principles of design
Risk assessment and risk reduction
EN 60204-1 2014 Safety of machinery – Electrical Equipment of machinery
Part 1: General requirements
EN 61000-6-2 2011 Electromagnetic compatibility (EMC)
Part 6-2: Generic standards immunity – for Industrial Environments
EN 61000-6-3 2011 Electromagnetic compatibility (EMC)
Part 6-3: Emission standard for residential, commercial and light
industrial environments
Furthermore, we declare that the technical documentation for this machinery was drawn up in
accordance with Annex VIII, Module A and we undertake, upon request, to provide the Market
surveillance authorities with these documents through our documentation department.
The officer in charge of the documentation is Mr. Kevin Kargar, Tel.: +49 711 31973-1179
Kreher (Managing Director) – 17/10/2019