Dismantling Operating manual - Fan CF-C
80 of 84 www.elektror.com 2004930 10.19/0.2
EN
Risk caused by lifting and transporting in an inappropriate way
The result of lifting and transporting the fan components in an
inappropriate way may be injuries and destruction of these
components.
Use only hoists, slings and fasteners with sufficient load capacity.
For transporting and lifting the fan, use the holes provided for this
purpose for transport lugs, slings and fasteners which should be in
perfect condition. It is possible to fasten only in the intended fixing
points of the transport lugs.
Do not tie wire ropes and chains.
Do not connect ropes by binding them.
Twisted ropes should be straightened before lifting.
Do not allow ropes to bend sharply.
Make sure that thimbles, rope eyes, rings and other elements of the
slings are freely movable on the hooks.
Do not carry loads over people.
Any auxiliary lugs, for example at the drive, etc. are only suitable for
suspending individual components.
Warning against damage resulting from improper storage
If you plan to mount the fan again after some time, remember that
improper storage can cause damage.
All components must be protected against corrosion.
− The fan should be covered.
10.5.1 Disposal (scope of application: EU Member States)
The producer offers the receipt of electrical and electronic components for the purpose of
their disposal in a lawful manner. Shipping costs ar
e borne by the sender.
All components belonging to the fan, together with electrical and electronic components and
consumables present in the fan and intended to bring it to readiness for work require only
disposal in a manner consistent with the law. T
heir disposal together with household waste or
ordinary industrial waste is strictly prohibited!
Electrical and electronic components:
For the disposal of electrical and electronic components, the European Directive 2002/96/EC
on electric and electronic w
aste and its transposition into applicable national law shall apply.
According to its provisions, electrical and electronic products shall be collected separately and
recycled in an environmentally friendly way.
Consumables:
When disposing of consumable
s, please follow the waste key numbers contained in the
content of the safety data sheets. Waste key numbers are a recommendation, unambiguous
determination should be made after possible consultation with the appropriate facility.
The disposal instructions
apply to the product and its residues after its use in a manner
consistent with its intended use. Mixing with other materials or preparations requires individual
evaluation.
To Next Page
Loading...