Elektror CF Series - Special Tools, Equipment and Material; Activities and Qualifications; Fan Transport; Table 5: Transport - Activities and Qualifications

Transport and storage Operating manual - Fan CF-C
28 of 84 www.elektror.com 2004930 10.19/0.2
EN
Head protection
An order to wear head protection when performing activities in conditions of risk of
falling objects or the possibility of hitting head against a hard object during normal body
movements.
5.3 Special tools, equipment and material
Products and materials which are assumed to be not a component of a typical workshop in an
industrial standard are considered special tool
s, devices and materials. At the stage of
"Transport " there is no need to use special tools, equipment and materials.
5.4 Activities and qualifications
Table 5: Transport – Activities and qualifications
Activity Qualification
Transport, operation of crane, operation of
lift trucks
Qualified personnel authorized to drive and operate the
transport and lifting equipment used. In addition, the
unloading and lifting of components should be entrusted only
to personnel who are qualified due to training in the area of
secure fastening of components in lashing points and using
load suspension devices and slings
Coordination of various activities An employee authorized to give instructions
5.5 Fan transport
This chapter describes the transport of the fan after transferring responsibility to the user
according to delivery conditions.
Risk due to the insufficient securing of load
DANGER
Loads that are not properly secured and loaded without taking into
account the
centre of gravity can move away from the vehicle that
transports them.
−
Load must be sufficiently secured with the use of approved
fasteners (belts, etc.).
−
The centre of gravity of the load must be taken into account.
−
The condition and bearing capacity of the transport vehicle must be
taken into account.
Risk of heavy objects falling from a height
DANGER
The suspended load may break off, it is possible that it swings or
catches persons. This can result in serious injury of the personnel and
material
damage.
−
Do not stand below a suspended load.
−
When replacing elements, always attach them carefully to
appropriate slings.
−
Avoid putting the suspended load in a swinging motion.
− The sub-contractors' documentation should be followed.