Operating manual - Fan CF-C Operation of the fan
2004930 10.19/0.2 www.elektror.com 71 of 84
EN
8.8.5.8 Lubricants data
The bearings are filled with a suitable quantity of grease at the factory and are ready for
operation.
types of grease presented in Table 25 are standard lubricants.
If other lubricants are to be used, please refer to the contents of the safety data sheets and the
"Operating manual".
8.8.6 After maintenance activities
After completing maintenance work and before turning on the fan, perform the following steps:
−
Make sure that all components removed during maintenance work are reassembled.
Make sure that any tools, materials and other equipment used are removed from the work
area.
− Clean the work area and dispose of any leakage of consumables.
8.9 Repair
Fan repairs generally require the involvement of the manufacturer or an authorized
represe
ntative. These persons are able to ensure that only original spare parts are used and
that the fan life span is extended.
In order to obtain technical information and purchase spare
parts, please provide all
data indicated on the nameplate.
8.9.1 Performing repairs
Before starting the repair:
−
Disconnect the electrical components from the mains supply.
Prepare the area of work and all the necessary elements for the planned course of work.
Prepare equipment necessary for installation / dismantling and tools.
Keep the workplace clean and tidy.
Prepare spare parts, only these recommended or provided by the manufacturer.
Special operating instructions must be followed.
Ambient conditions
lubricant
Normal climatic conditions
(ambient temperature from
– 5°C to +40°C)
SKF LGHP 2
Low temperatures
(ambient temperature to -
40°C)
To Next Page
Loading...