Operating manual - Fan CF-C Transport and storage
2004930 10.19/0.2 www.elektror.com 31 of 84
EN
3. Raise the pallet evenly.
Note:
When lifting, move the crane horizontally to maintain the position of the pivot point.
4. The pallet should be transported to the place of installation.
5. Carefully set the pallet in the place of installation.
Result:
The fan is located in the place of installation as intended.
Transport of pallets in a horizontal position with a forklift
The transport of pallets in a horizontal position with a forklift requires
the use of the fo
llowing auxiliary elements:
1 x Forklift with suitable forks
Using the auxiliary elements mentioned above, taking into account the following steps, lift the
fan, transport it and set it to a horizontal position in the installation site.
1. Slide the forks of the forklift under the pallet or between the pallet feet.
2. Raise the pallet evenly horizontally so that it can be detached from the ground.
3. The pallet should be transported to the place of installation.
4. Carefully set the fan in the place of installation.
Result:
The fan is located in the place of installation as intended.
5.6 Packaging
The fan is prepacked in accordance with the requirements of:
−
transport route
storage at the customer's
customer's request
on the pallet
directly on the truck
packaging in a closed wooden box
in a container
Further transport of the fan should be carried out only with appropriate protection:
transport security
protective cover (foil)
drying material
The protection "protective cover (foil)" and "dryin
g material" prevent penetration of foreign
particles and moisture into the fan or components of electrical equipment.
To Next Page
Loading...