Elma Elmasolvex VA - Page 37

Daily cleaning operation
© Elma Schmidbauer GmbH BA_Elmasolvex_VA_EN_Vers.05.2018
37
Fig. 6.3.3 Display Safety test progress
After performing the safety test, the cleaning machine
automatically continues with the selected cleaning program.
After a short initialisation phase of 30 seconds, the cleaning
machine starts filling the cleaning chamber by the resulting
vacuum.
This process is shown on the display (Fig. 6.3.4).
Fig. 6.3.4 Display Status of the program progress
After completion of the initialisation phase, the corresponding
notification in the display is cleared and the cleaning program is
started.
The remaining time until the end of the cleaning program is
displayed.
If you have a pager, you can initialise this now (for description,
see Chapter 15 Appendix 2: Pager).
The detailed progress of the cleaning program can be shown on
the display (Fig. 6.3.5): Press the corresponding operating
button (Fig.6.3.4) to display this function.
Initialisation phase
Start of the cleaning
program
Initialising pager
(optional accessory)
Progress display of the
cleaning program