Operating faults
© Elma Schmidbauer GmbH BA_Elmasolvex_VA_EN_Vers.05.2018
11.2 Cleaning machine faults without indication on
the display
Cleaning machine cannot be
started or stops.
Check the following possibilities:
• Disconnect cleaning machine from the mains power supply. Then
check fuse(s) for mains cable; replace if necessary
• Switch off cleaning machine and restart:
Contact Service if the fault persists
Liquid discharge from
bottom case opening.
Check the following possibilities:
• Check media tank filling level
• Cleaning deflagration protection (see Chapter 11.3.1)
• Contact Service if the fault persists
11.3 Fault clearance by user
Risk of electric shock from live parts in the interior of the
cleaning machine!
Always unplug the mains plug before opening the cleaning
machine.
The manufacturer shall accept no liability for damage caused by
unauthorised interventions on the cleaning machine.
Risk of injury from sharp edges in the cleaning machine and
from moving / rotating components (e.g. toothed belts).
Risk of injury from hot surfaces!
The vacuum pump, solenoid valves, drives and heater can still
be hot immediately after operation of the cleaning machine.
To Next Page
Loading...