ELTEX MES3108 - Page 107

MES3000 Ethernet switch series 107
 View LLDP configuration:
console# show lldp configuration
LLDP state: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Port State Optional TLVs Address
---------- ---------------- ------------------------ ---------------
gi0/1 Rx and Tx PD, SN, SD 192.168.16.55
gi0/2 Rx and Tx
…
gi0/22 Rx and Tx
More: <space>, Quit: q, One line: <return>
Table 5.107 —Description of results
Field
Description
Timer
Define the frequency of LLDP updates sent by the device.
Hold multiplier
Specify the amount of time (TTL, Time-To-Live) for the receiving device to keep LLDP
packets before dropping them: TTL = Timer * Hold multiplier.
Reinit delay
Define the minimum amount of time, that the port will wait before sending the next
LLDP message.
Tx delay
Define the delay between the subsequent LLDP frame transmissions, initiated by
changes of values or status.
Port
Port number.
State
Port operation mode for LLDP.
Optional TLVs
TLV options being sent
Possible values:
PD—port description
SN—system name
SD—system description
SC—system capabilities
Address
Device address being send in LLDP messages.
Notifications
Define whether LLDP notifications are enabled or disabled.
 Show information on neighbouring devices:
console# show lldp neighbors
Port Device ID Port ID System Name Capabilities
--------- ---------------- -------- ---------- -------------
gi0/1 0060.704C.73FE 1 ts-7800-2 B
gi0/2 0060.704C.73FD 1 ts-7800-2 B
gi0/3 0060.704C.73FC 9 ts-7900-1 B, R
gi0/4 0060.704C.73FB 1 ts-7900-2 W
show lldp neighbors gigabitethernet 1/0/20
Device ID: 02:10:11:12:13:00
Port ID: gi0/23
Capabilities: B