ELTEX MES3108 - Page 110

110 MES3000 Ethernet switch series
no ethernet oam
unidirectional detection
discovery-time
Restore the default value.
Privileged EXEC mode commands
All commands are available to the privileged user. Command line request in privileged EXEC mode
appears as follows:
console#
Table 5.110 —Privileged EXEC mode commands
Command
Value/Default value
Action
clear ethernet oam statistics
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port}]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Clear Ethernet OAM statistics for the selected interface.
show ethernet oam discovery
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port}]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Show Ethernet OAM protocol state for the selected interface.
show ethernet oam statistics
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port}]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Show protocol message exchange statistics for the selected
interface.
show ethernet oam status
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port}]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Show Ethernet OAM settings for the selected interface.
show ethernet oam
unidirectional detection
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port}]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Show the state of one-way communication detection mechanism
for the selected interface.
Example execution of commands
 Show protocol state for gigabitethernet 1/0/3 port:
console#show ethernet oam discovery interface GigabitEthernet 0/3
gigabitethernet 1/0/3
Local client
------------
Administrative configurations:
Mode: active
Unidirection: not supported
Link monitor: supported
Remote loopback: supported
MIB retrieval: not supported
Mtu size: 1500
Operational status:
Port status: operational
Loopback status: no loopback
PDU revision: 3
Remote client
-------------
MAC address: a8:f9:4b:0c:00:03
Vendor(oui): a8 f9 4b
Administrative configurations:
PDU revision: 3
Mode: active