ELTEX MES3108 - Page 121

MES3000 Ethernet switch series 121
no bridge multicast ipv6
source ipv6_address group
ipv6_multicast_address
Restore the default value.
bridge multicast ipv6
forbidden source ipv6_address
group ipv6_multicast_address
{add | remove}
{gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group}
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Disable adding/removal of matches between the user IPv6 address
and the multicast address in the multicast addressing table for the
specific port.
- ipv6_address—source IPv6 address
- ipv6_multicast_address—multicast IPv6 address
- add—disable port adding to the source IPv6 address group
- remove—disable port removal from the source IPv6 address
group
no bridge multicast ipv6
forbidden source ipv6_address
group ipv6_multicast_address
Restore the default value.
bridge multicast unregistered
{forwarding | filtering}
-/forwarding
Set rules for packet transmission from unregistered group
addresses.
- forwarding – transmit unregistered multicast packets
-filtering - filter unregistered multicast packets
no bridge multicast
unregistered
Restore the default value.
Ethernet interface configuration mode commands (interface range), port group interface
Command line request in Ethernet interface, port group interface configuration mode appears as
follows:
console# configure
console(config)# interface {tengigabitethernet te_port | gigabitethernet
gi_port |port-channel group | range {…}}
console(config-if)#
Table 5.124 —Ethernet interface configuration mode commands, interface group
Command
Value/Default value
Description
bridge multicast unregistered
{forwarding | filtering}
-/forwarding
Set the forwarding rule for packets received from unregistered
multicast addresses.
- forwarding—forward unregistered multicast packets
- filtering—filter unregistered multicast packets
no bridge multicast
unregistered
Restore the default value.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.125 —Global configuration mode commands
Command
Value/Default value
Description
bridge multicast filtering
-/disabled
Enable multicast address filtering.
no bridge multicast filtering
Disable multicast address filtering.
mac address-table aging-time
seconds
seconds:
(10..86400)/300
seconds
Define MAC address lifetime in table globally.
Aging time for MAC address started from 600 seconds can be set
only with 300 second intervals (900, 1200, 1500 etc.) For small
values of aging-time (less than 600 seconds) error, which
commensurate with its value, is permissible. With increasing
values of aging-time error is decreased.
no mac address-table
agingtime
Restore the default value.
mac address-table aging-time
seconds vlan vlan_id
seconds:
(10..86400)/300;
vlan_id: (1..4094)
Set aging-time for MAC-address in table for VLAN
no mac address-table
Restore the default value.