ELTEX MES3108 - Page 126

126 MES3000 Ethernet switch series
ip igmp snooping vlan vlan_id
proxy-report [version version]
vlan_id: (1..4094);
version: (1..3)
Enable mode in which switch sends report to query requests of
static groups that are configured on it. In this case IGMP-
report/leave messages for static groups are ignored.
- version– specify version of report/leave messages, which are
sent by proxy-reporter.
All IGMP messages created by proxy reporter are IGMPv3 by
default. Answers to query messages are in the same version in
which IGMP-query was sent
no ip igmp snooping vlan
vlan_id proxy-report
Restore the default value.
ip igmp snooping vlan vlan_id
cos cos
vlan_id: (1..4094);
cos: (0..7)
Set value for parameter field of IEEE 802.1p priority
no ip igmp snooping vlan
vlan_id cos
Restore the default value.
VLAN interface configuration mode commands
Command line request in VLAN configuration mode appears as follows:
console(config-if)#
Table 5.129 —VLAN interface configuration mode commands
Command
Value/Default value
Action
ip igmp robustness count
count: (1..7)/2
Define IGMP stability value.
If the data loss is discovered for the channel, stability value should
be increased.
no ip igmp robustness
Restore the default value.
ip igmp query-interval seconds
seconds:
(30..18000)/125
seconds
Define the timeout upon the expiration of which, the system will
send basic queries to check the activity of multicast group
participants.
no ip igmp query-interval
Restore the default value.
ip igmp
querymaxresponsetime
seconds
seconds: (5..20)/10
seconds
Set the maximum query response time.
no ip igmp
querymaxresponse-time
Restore the default value.
ip igmp
lastmemberquerycount
count
count:
(1..7)/robustness value
Define the quantity of queries sent before the switch will
determine the absence of multicast participants.
no ip igmp
lastmemberquerycount
Restore the default value.
ip igmp
lastmemberqueryinterval
milliseconds
milliseconds:
(100..25500)/1000 ms
Define the query interval for the last participant.
no ip igmp
lastmemberqueryinterval
Restore the default value.
Ethernet interface configuration mode commands (interface range)
Command line request in interface configuration mode appears as follows:
console(config-if)#
Table 5.130 —Ethernet interface configuration mode commands
Command
Value/Default value
Action
switchport access multicast-tv
vlan vlan_id
vlan_id: (1..4094)
Enable forwarding of IGMP queries from client VLAN to Multicast
VLAN and multicast traffic to client VLAN for the interface in
'access' mode.