ELTEX MES3108 - Page 143

MES3000 Ethernet switch series 143
no snmp-server enable traps
mac-notification change
Disables SNMP trap message transmission on changes in table of
learnt MAC addresses.
snmp-server enable traps
macnotification flapping
-/enabled
Enable SNMP trap message transmission on detection of MAC
addresses flapping
no snmp-server enable traps
mac-notification flapping
Disable SNMP trap message transmission on detection of MAC
addresses flapping
snmp-server enable traps
l2protocol-tunnel
-/disabled
Enable SNMP trap message transmission on drop-threshold and
shutdown threshold activity in L2PT
no snmp-server enable traps
l2protocol-tunnel
Disable SNMP trap message transmission in L2PT
snmp-server enable traps
storm-control
-/enabled
Enables SNMP trap message transmission upon detection of
broadcast storm.
no snmp-server enable traps
storm-control
Disables SNMP trap message transmission upon detection of
broadcast storm.
snmp-server trap
authentication
-
Allow to send messages to non-authenticated trap server.
no snmp-server trap
authentication
Deny to send messages to non-authenticated trap server.
snmp-server contact text
text: (1..160)
characters
Define the device contact information.
no snmp-server contact
Remove the device contact information.
snmp-server location text
text: (1..160)
characters
Define the device location information.
no snmp-server location
Remove the device location information.
snmp-server set variable_name
name1 value1 [name2 value2
…]
variable_name, name,
value should be defined
according to
specification
Allows to set variable values in the switch MIB database.
- variable_name—variable name
- name, value—match pairs 'name—value'.
Ethernet interface configuration mode commands (interface range)
Command line request in Ethernet interface configuration mode appears as follows:
console(config-if)#
Table 5.154 —Ethernet interface configuration mode commands
Command
Value/Default value
Action
snmp trap link-status
-/enabled
Enable SNMP trap message transmission on the configured port
state changes.
no snmp trap link-status
Disable SNMP trap message transmission on the configured port
state changes.
Privileged EXEC mode commands
Command line request in Privileged EXEC mode appears as follows:
console#
Table 5.155 —Privileged EXEC mode commands
Command
Value/Default value
Action
show snmp
Show SNMP connection status.
show snmp engineID
Show the local SNMP device identifier—engineID.
show snmp views [viewname]
viewname: (1..30)
characters
Show SNMP browsing rules.
show snmp groups
[groupname]
groupname: (1..30)
characters
Show SNMP groups.
show snmp filters [filtername]
filtername: (1..30)
characters
Show SNMP filters.
show snmp users [username]
username: (1..24)
characters
Show SNMP users.