ELTEX MES3108 - Page 54

54 MES3000 Ethernet switch series
no sntp client enable
{gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group| vlan
vlan_id}
Restore the default value.
sntp unicast client enable
-/denied
Allow unicast SNTP client operation.
no sntp unicast client enable
Restore the default value.
sntp unicast client poll
-/denied
Allow sequential polling of the selected unicast SNTP servers.
no sntp unicast client poll
Restore the default value.
sntp server {ipv4_address |
ipv6_address | ipv6z_address |
hostname} [poll] [key keyid]
hostname: (1..158)
characters;
keyid: (1..4294967295)
Define SNTP server address.
- ipv4_address—Ipv4 address of the network node.
- ipv6_address—Ipv6 address of the network node.
- ipv6z_address—Ipv6z address of the network node for ping.
Address format {ipv6-link-local-address}%{interface-name}
ipv6_link_local_address—local link IPv6 address
interface_name—name of the source interface is specified in
the following format:
vlan {integer} | ch {integer} | isatap {integer} | {physical-port-
name}
- hostname—domain name of the network node
- poll—enable polling
- keyid—key identifier
no sntp server {ipv4_address |
ipv6_address | ipv6z_address |
hostname}
Delete the server from NTP server list.
sntp port port_number
port_number:
(1..65535)/123
Define UDP port of SNTP server.
no sntp port
Restore the default value.
clock dhcp timezone
-/denied
Allow to get the timezone and daylight saving data from DHCP
server.
no clock dhcp timezone
Deny to get the timezone and daylight saving data from DHCP
server.
Interface configuration mode commands
Command line request in interface configuration mode appears as follows:
console(config-if)#
Table 5.29 —List of system time configuration commands in the interface configuration mode
Command
Value/Default value
Action
sntp client enable
-/denied
Allow the operation of SNTP clients that support packet
transmission to the nearest device in a group of receivers, and to
broadcast SNTP client for the selected interface (ethernet, port-
channel, VLAN).
no sntp client enable
Restore the default value.
Example execution of commands
 Show the system time, date and timezone data:
console# show clock detail
15:29:08 PDT(UTC-7) Jun 17 2009
Time source is SNTP
Time zone:
Acronym is PST
Offset is UTC-8
Summertime:
Acronym is PDT
Recurring every year.