ELTEX MES3108 - Page 57

MES3000 Ethernet switch series 57
Given below are commands for entering the configuration mode of the Ethernet interface range
from 1 to 10 and entering the configuration mode of all port groups.
console# configure
console(config)# interface range gigabitethernet 1/0/1-10
console(config-if)#
console# configure
console(config)# interface range port-channel 1-8
console(config-if)#
Table 5.30 —Ethernet and Port-Channel interface configuration mode commands
Command
Value/Default value
Action
shutdown
-/enabled
Disable the configured interface (Ethernet, port-channel).
no shutdown
Enable the configured interface.
description descr
descr: (1..64)
characters/no
description
Add interface description (Ethernet, port-channel).
no description
Remove interface description.
speed mode
mode: (10, 100, 1000,
10000)
Set data transfer rate (Ethernet, port-channel).
For xg(1-4) ports, you can change the rate (1000-10000)
no speed
Set the default value.
media-type {force-fiber |
force-copper | preferfiber |
prefercopper}
-/prefer-fiber
- force-fiber - only fiber part of a combo-port activity is allowed.
- force-copper- only copper part of a combo-port activity is
allowed.
- prefer-fiber -privilege of fiber link
- prefer-copper -privilege of copper link
Only for combo-ports
no media-type
Restore the default value
duplex mode
mode: (full, half)/full
Define interface duplex mode (full-duplex connection, half-duplex
connection, Ethernet).
This command is not available for XG1- XG4 ports
no duplex
Set the default value.
negotiation [cap1
[cap2…cap5]]
cap: (10f, 10h, 100f,
100h, 1000f)
Enables autonegotiation of speed and duplex on the configured
interface. You can define the specific compatibility
autonegotiation parameters; if these parameters are not defined,
all compatibilities are supported (Ethernet, port-channel).
This command is not available for XG1- XG4 ports
no negotiation
Disable autonegotiation of speed and duplex on the configured
interface.
flowcontrol mode
mode: (on, off,
auto)/off
Define the flow control mode (enable, disable or autonegotiation).
Flowcontrol autonegotiation works only when negotiation mode is
enabled on configured interface (Ethernet, port-channel).
no flowcontrol
Disable flow control mode.
mdix mode
mode: (on, auto)/auto
Enable the crossed cable utilization for the configured interface
(Ethernet).
This command is not available for XG1- XG4 ports
no mdix
Disable the crossed cable utilization for the configured interface
(Ethernet).
back-pressure
-/disabled
Enable 'backpressure' function for the configured interface
(Ethernet).
no back-pressure
Disable 'backpressure' function for the configured interface.
load-average period
period: (5..300/15)
Specify the period of load statistics collection for the interface.
no load-average
Set the default value.