ELTEX MES3108 - Page 58

58 MES3000 Ethernet switch series
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.31 —Ethernet and Port-Channel interface general configuration mode commands
Command
Value| Default value
Action
port jumbo-frame
-/denied
Enable processing of jumbo fames by the switch.
Maximum transmission unit (MTU) default value is
1500 bytes.
Configuration changes will take effect after the switch
is restarted.
Maximum transmission unit (MTU) value for port
jumbo-frame configuration is 10'200bytes.
no port jumbo-frame
Disable processing of jumbo fames by the switch.
errdisable recovery cause
{loopack-detection |
portsecurity |
dot1xsrcaddress | acldeny |
stpbpduguard |
stploopback-guard}
-/denied
Enable automatic interface activation after its disconnection in the
following circumstances:
- loopback-detection—loopback-detection
- port-security—security breach for port security
- dot1x-src-address—user MAC authentication failed
- acl-deny—non-compliance with access lists (ACL)
- stp-bpdu-guard—BPDU Guard activation (unauthorized BPDU
packet reception via the interface)
- stp-loopback-guard—loopback detection using the STP protocol.
no errdisable recovery cause
{loopack-detection | port-
security | dot1xsrcaddress |
acldeny | stpbpduguard |
stploopback-guard}
Set the default value.
errdisable recovery interval
seconds
seconds:
(30..86400)/300
seconds
Define the time period for automatic interface reactivation.
no errdisable recovery interval
Set the default value.
default interface [range]
{gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group }
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Resets configuration of an interface or a group of interfaces to
default.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.32 —EXEC mode commands
Command
Value
Action
clear counters
-
Reset statistics for all interfaces.
clear counters {gigabitethernet
gi_port | tengigabitethernet
te_port | port-channel group}
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Reset statistics for Ethernet port, port group.
set interface active
{gigabitethernet gi_port |
tengigabitethernet te_port|
port-channel group}
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Activate port or port group, disabled with the shutdown
command.
show interfaces configuration
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Show the interface configuration.