ELTEX MES3108 - Page 67

MES3000 Ethernet switch series 67
vlan statistics egress low
-/disable
Enable egress traffic counter for VLAN 1...2047 (only for
standalone mode).
no vlan statistics egress low
Disable egress traffic counter for VLAN 1...2047 (only for
standalone mode).
vlan statistics egress high
-/disable
Enable egress traffic counter for VLAN 2048...4094 (only for
standalone mode).
no vlan statistics egress high
Disable egress traffic counter for VLAN 2048...4094 (only for
standalone mode).
There are four blocks of counters:
 Ingress 1..2047
 Ingress 2048..4094
 Egress 1..2047
 Egress 2048..4094
No more than two blocks can be enabled simultaneously. If qos statistics mode (qos
statistics interface) is enabled, only one block of counters can be enabled at the same
time.
Only two counters can be used for each VLAN in one direction (rx or tx): frames and
packets without distinction on multicast/unicast/broadcast
Example execution of the command:
console# configure
console(config)# vlan database
console(config-vlan)#
Privileged EXEC mode commands
Command line request in Privileged EXEC mode appears as follows:
console#
Table 5.39 —Privileged EXEC mode commands
Command
Value
Action
show vlan
-
Show information on all VLANs
show vlan name name
name: (1..32)
characters
Show information on VLAN, search by name
show vlan tag vlan_id
vlan_id: (1..4094)
Show information on VLAN, search by ID
show vlan internal usage
-
Show VLAN list for internal use by the switch.
show
defaultvlanmembership
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Show default VLAN group content.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console>
Table 5.40 —EXEC mode commands
Command
Value
Action
show vlan multicast-tv vlan
vlan_id
vlan_id: (1..4094)
Show source ports and multicast traffic receivers in the current
VLAN. Source ports can send and receive the multicast traffic.
show vlan protocolsgroups
-
Show information on protocol groups.
show vlan macs-groups
-
Show information on MAC address groups.