ELTEX MES3108 - Page 96

96 MES3000 Ethernet switch series
received.
spanning-tree link-type
{pointto-point | shared}
Default value for full-
duplex port—'point-to-
point', for half-duplex—
split'.
Define the transfer state for RSTP protocol and specify the
connection type for the selected port—'point-to-point' or 'split'.
no spanning-tree link-type
Restore the default value.
spanning-tree bpdu {filtering |
flooding}
-
Define BPDU packet processing mode by the interface with
disabled STP protocol.
- filtering—packets are filtered for the interface with STP BDPU
protocol disabled
- flooding—untagged BDPU packets are transmitted for the
interface with STP protocol disabled, tagged packets are filtered
no spanning-tree bpdu
Restore the default value.
spanning-tree binding-process
id
id: (1..31)/0
Tethers the port to the specific process. By default, all ports are
controlled by the zero process.
- id—the process number.
no spanning-tree
bindingprocess
Restore the default port tethering.
Table 5.87 —Route value set by default (spanning-tree cost)
Interface
Method for defining the path
value.
Long
Short
Port-channel
20000
4
TenGigabit Ethernet (10000 Mbps)
2000
2
Gigabit Ethernet (1000 Mbps)
20000
4
MSTP process configuration mode commands
Command line request in process configuration mode appears as follows:
console(config-mstp-process)#
Table 5.88 —Privileged EXEC mode commands
Command
Value/Default value
Action
spanning-tree forward-time
seconds
seconds: (4..30)/15
seconds
Set the time interval for state listening and learning of configured
process before switching to the interchange mode.
no spanning-tree forward-time
Restore the default value.
spanning-tree hello-time
seconds
seconds: (1..10)/2
seconds
Set the interval for 'Hello' broadcast message transmission to
communicating switches.
no spanning-tree hello-time
Restore the default value.
spanning-tree max-age
seconds
seconds: (6..40)/20
seconds
Set the lifetime of the spanning tree.
no spanning-tree max-age
Restore the default value.
spanning-tree mst instance_id
priority priority
instance_id: (1..4094);
priority:
(0..61440)/32768
Set the switch priority value in the selected MST instance.
- instance_id–MST instance;
- priority–priority of a switch
Priority value must be divisible by 4096.
no spanning-tree mst
instance_id priority
Restore the priority default value.
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.89 —Privileged EXEC mode commands
Command
Value
Action
show spanning-tree [process
gi_port: (1..8/0/1..24);
Show STP configuration for the selected process.