ELTEX MES3108 - Page 97

MES3000 Ethernet switch series 97
id] [gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
te_port: (1..8/0/1..4);
group: (1..24)
id: 0..31
show spanning-tree [detail]
[active | blockedports]
[process id]
id: 0..31
Show the detailed information on STP configuration, information
on active or blocked ports
clear spanning-tree
detectedprotocols
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Restart protocol migration process. Begin spanning tree
recalculation.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.90 —EXEC mode commands
Command
Value
Action
show spanning-tree bpdu
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Show BDPU packet processing mode for the interfaces.
5.15.5.2 MSTP protocol configuration
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.91 —Global configuration mode commands
Command
Value/Default value
Action
spanning-tree
-
Enable STP utilization by the switch.
no spanning-tree
Disable STP utilization by the switch.
spanning-tree mode {stp |
rstp | mstp}
-/rstp
Set STP operation mode.
no spanning-tree mode
Restore the default value.
spanning-tree pathcost
method {long | short}
-/short
Set the method for defining the path value.
- long—value in the range 1..200000000
- short—value in the range 1..65535.
no spanning-tree pathcost
method
Restore the default value.
spanning-tree mst instance_id
priority priority
instance_id: (1..4094);
priority:
(0..61440)/32768
Set the higher priority for the current switch than for other
switches that use the common MSTP instance.
- instance_id—MST instance.
- priority—priority of a switch.
Priority value must be divisible by 4096.
no spanning-tree mst
instance_id priority
Restore the default value.
spanning-tree mst max-hops
hop_count
hop_count: (1..40)/20
Set the maximum transit portions for BDPU packet required for
the tree formation and keeping the information on its structure. If
the packet has gone through the maximum quantity of transit
portions, it will be discarded at the next portion.
no spanning-tree mst
maxhops
Restore the default value.
spanning-tree mst
configuration
-
Enter the MSTP configuration mode.