To Next Page

To Previous Page

VNX File configuration worksheet

With your network administrator, determine the IP addresses and network parameters

you plan to use with the storage system, and record the information on the following

worksheet. You must have this information to set up and initialize the system.

You manage the storage system through a dedicated LAN port on each storage processor.

These ports must share a subnet with the host you use to initialize the system. After

initialization, any host on the same network and with a supported browser can manage

the system through the management ports.

Record network information for your system on the worksheets on the next pages. Your

network administrator should provide most of this information. For more information,

refer to your configuration planning guide.

To download the latest version of the VNX Installation Assistant for File/Unified, go to the

https://support.emc.com and select Support. Search for VNX Installation Assistant.

Note

The VNX Installation Assistant for File/Unified auto-discovers and pre-populates certain

values based on the system and network environment of your Windows client. Ensure you

verify and fill these values in to the Value column by recording the results of the auto-

discovery.

Table 5 Control Station public LAN settings

Field Value Comments

CS0 Primary

hostname

CS1 Secondary

hostname

CS0 Primary IP

address

If you want to configure IPv6 addresses for the Control

Station address, use the VNX Installation Assistant for

File/Unified for the initial installation, and then refer to

the

Configuring and Managing Networking on VNX

technical module and the

EMC VNX Command Line

Interface Reference for File

to complete the IPv6

additions.

CS1 Secondary

IP address

Netmask Auto-discovered (optional). Enter this information into