February 2019
User Instructions
MAN-02-04-60-0350-EN Rev. 3
23
Section 5: Commissioning
Commissioning
Display Overview:
1. Absolute value,
2. Relative value
Step 8 - When the desired end position OPEN of the valve is reached, move the selector
switch back to the middle position. Thus, the line "TEACHIN" disappears.
Figure 22 Selector for End Position (Save)
Figure 23 End Position Display
Step 9 - In order to conrm the end position (save), slightly ip up the selector switch
towards and let it snap back to its neutral position.
Figure 24 Selector Setting Save (1)
To Next Page
Loading...
