User Instructions
MAN-02-04-60-0350-EN Rev. 3 February 2019
36
Section 6: Control Unit
Control Unit
Step 6 - If the value changes to 1, conrm the selection by ipping halfway up the selector
switch (towards) and letting it snap back to its neutral position (see Figure 42 til Figure 46).
Figure 49 Selector Switch Flipped Halfway Up
Figure 50 Display After Confirming Selection
Step 7 - This changes the bottom line of the display from "SAVE?" to "EDIT?" and the
parameter is stored.
6.3.4 "TEACHIN“
Furthermore, certain parameters (end positions, intermediate positions), can be
set using "TEACHIN". Thus, their conguration is greatly simplied.
After selecting the appropriate menu item (for example: End position) and
chanching the the input type from "EDIT?" to "SAVE?", move the selector switch
(red) to "manual mode" and lock it into place. As you do so, the display will show
the message "TEACHIN" and the current position value will be applied continuously
to the parameter value. In this mode, further to manual operation by hand wheel,
the actuator can be motor-driven with the control switch to the desired position.
(see Section 5.4.1)
To Next Page
Loading...
