Emerson EZMotion - Uploading and Downloading Using Powertools Pro; Uploading

26 EZMotion User/Programming Guide
www.controltechniques.com Revision: A8
The user can configure the maximum number of node addresses they wish to poll when uploading or Flash Upgrading devices.
PowerTools Pro will not check to see if any devices with node addresses higher than the number entered are available on the
network. The default number is 4 with a maximum number of 32 node addresses.
Figure 24: PowerTools Pro Preferences Window - Communications Tab
5.4 Uploading and Downloading using PowerTools Pro
Figure 25 will be used throughout the Uploading and Downloading section of the manual to describe certain processes.
Figure 25: Memory Storage in the EZMotion
5.4.1 Uploading
Uploading is the process of reading the configuration stored in EZMotion and loading that data into a configuration file on the PC.
Arrow B in Figure 25 represents a standard Upload. To upload a configuration from EZMotion, click the Upload button on the
PowerTools Pro toolbar or on the Device menu, click Upload.
PC with PowerTools Pro
Non-User NVM
User NVM
RAM
A
B
C
F
D
H
E
G
EZ Motion