Emerson EZMotion User Manual

Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics
Glossary Index
EZMotion User/Programming Guide 243
Revision A8 www.controltechniques.com
Close - The Close button will close the Select Drive Parameters window, while the Watch Window will remain open.
Help - The Help button will give associated help on the Watch Window setup.
User Level - The User Level setting is a filter for the parameters that are seen in the Select Drive Parameters list. If set to
Easy, the parameters used in most basic applications will be seen while the more advanced parameters are hidden. If User
Level is set to Detailed, the parameters used in more advanced applications will be added to the list. If set to Too Much, then
all parameters available in the system will be seen in the list. This allows the user to select the User Level they are most
comfortable with to avoid confusion. If a parameter has been selected and the User Level is changed, then the selected
parameter will remain selected.
Within the Select Parameters window the user can change the value of parameters in the drive’s RAM memory. Click on a
parameter in the Parameters Displayed in Watch Window pane. Just below the pane the parameter that was selected will be
shown along with either a check box, text box or list box. The type of box is depended on the parameter selected. Enter the
new parameter value and press the Write button.The data should change in the watch window to the new value.
14.3.2 Errors View
The Errors View in PowerTools Pro helps the user diagnose problems by displaying any active errors or trips. If online when an
error activates, an error pop-up window will appear that shows the active error. There are two buttons on the pop-up window
that allow the user to clear an error and trip or simply ignore it and remove the pop-up window. An example of the pop-up
window is shown in Figure 183.
MotionStop False Motion is stopped on motion stop.
SoftDriveDisable False Motion is prevented by SoftDriveDisable.
AbsolutePosnValid True
Absolute indexes can not executed until the Absolute
position is defined.
InPosn True
If using "In Position" the last index is not considered
complete until this status is met. So motion will stop if
you can not achieve in position. While running this is
expected to be false as it is only true at the end of a
move and prior to starting a new move.
Feedhold False Feed Hold stops motion.
FeedRateOverride 100%
Feed rate scales the speed of the Motion. 100%
scaling indicates one to one scaling.
FeedRateDeactivate False / True
Activate to disable FeedRate. If feedrate is 100% it
does not matter.
FoldbackActive False
When Foldback is active it indicates a current
overload and the Foldback circuit is limiting the
current. Foldback in it’s self indicates motor selection
of wiring problems that effect motor motion.
SoftwareTravelLimitMinusActive False Motion stops when a travel limit is active.
SoftwareTravelLimitPlusActive False Motion stops when a travel limit is active.
TorqueLimitActive False
Torque limits may effect motor motion as it reduces
motor generated torque.
Profile.0.MotionStop False
Each profile has it’s own Stop. To get motion out of
this profile this parameter must be false.
Profile.0.FeedHold False
Each profile has it’s own Feedhold. To get motion out
of this profile this parameter must be false.
Profile.1.MotionStop False
Each profile has it’s own Stop. To get motion out of
this profile this parameter must be false.
Profile.1.FeedHold False
Each profile has it’s own Feedhold. To get motion out
of this profile this parameter must be false.
Parameters Expected Value to get Motion Comments

Emerson EZMotion Specifications

General

Brand	Emerson
Model	EZMotion
Category	Control Unit
Language	English