Emerson EZMotion - Watch Window

Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics
Glossary Index
EZMotion User/Programming Guide 241
Revision A8 www.controltechniques.com
Figure 180: Analog Output Example
For more details on the Analog Output of the drive, refer to the Unidrive SP User Guide or Unidrive SP Advanced User Guide.
14.3 PowerTools Pro
14.3.1 Watch Window
PowerTools Pro contains a diagnostic utility called the Watch Window. The Watch Window can be used while PowerTools Pro
is online with EZMotion. The Watch Window allows the user to monitor the status of all of their desired system parameters in
one location. An example of the Watch Window is found in Figure 181.
Figure 181: Watch Window Example
To setup the Watch Window, select Tools > Watch Window from the PowerTools Pro menu bar. If not online with the module,
the Watch Window will be a unavailable on the menu. Upon selecting Watch Window, the Select Drive Parameters window will
open.
The Select Drive Parameters window, as seen in Figure 182, allows the user to specify which parameters are to be viewed in
the Watch Window. To select a parameter for the Watch Window, simply click once on the parameter and it will be added to the
Watch Window. The parameters already in the Watch Window will be highlighted in the Select Drive Parameters window.
Menu 7
20.217.19
7.20
7.18
7.17
7.16
7.15
7.14
7.13
7.12
7.11
7.10
7.09
7.08
7.07
7.06
7.05
7.04
7.03
7.02
7.01
Menu 20
20.15
20.16
20.17
20.18
20.19
20.20
20.21
20.22
20.23
20.24
20.25
20.26
20.27
20.28
20.29
20.30
20.31
20.32
20.33
20.34
Var.Var0 = 12.34
Do While TRUE
Menu.20.21 = Var.Var0
Loop
12.34
Anaolg Output Value
12.34
EZMotion Program 0