Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics Glossary Index
EZMotion User/Programming Guide 27
Revision A8 www.controltechniques.com
Figure 26: Upload Drive Configuration Dialog Box
The Upload Drive Configuration dialog box will open, all communication connections are scanned and the results appear. The
Upload Drive Configuration dialog box contains the following information for every device found:
• IP Address/COM
• Modbus Address ID
•Drive Type
• Module Type
• Communication Options
• Base/Drive Revision
• Module Revision
• Module Serial Number
•Drive Serial Number
Select the device to upload and click Upload.
5.4.2 Downloading
Downloading is the process of sending the PowerTools Pro configuration from the PC to EZMotion. Changes made in
PowerTools Pro will not take effect until the information has been downloaded or the Update to RAM button has been clicked.
Arrow A in Figure 25 represents a standard Download.
To download information to EZMotion, click on the Download button on the PowerTools Pro toolbar or select Device >
Download from the menu bar.
Figure 27: Download Drive Configuration Dialog Box
The Download to Device IDx (x = the node address of the drive) dialog box will open, all communication connections are
scanned and the results appear. The Upload Drive Configuration dialog box contains the following information for every device
found:
To Next Page
Loading...
