Emerson EZMotion User Manual

Safety
Information
Introduction
Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics Glossary Index
EZMotion User/Programming Guide 5
Revision A8 www.controltechniques.com
2.4 Solution Module Compatibility Chart
The table below shows what solution modules are compatible with the SM-EZMotion module as well as the firmware revision
and the version of PowerTools software needed to program the combinations.
1
- indicates that this module can be used along with SM-EZMotion, but is not directly configured by PowerTools Pro.
Therefore, the user must write a custom program to handle the parameter passing to/from the solutions module.
2
- indicates that support for this module was introduced in earlier rev than indicated, but user is required to use the revision
shown for proper operation.
Module Compatible with
SM-EZMotion
Configured by
PowerTools Pro
PowerTools Pro
Rev Required
SM-EZMotion
Firmware Rev
Required
SM-Resolver X X 3.0 or greater A3 or greater
SM-Universal Encoder Plus X X 3.0 or greater A3 or greater
SM-Encoder Plus
SM-I/O Plus X X 3.0 or greater A3 or greater
SM-I/O Timer X
1
Any Any
SM-I/O PELV X
1
Any Any
SM-I/O 24V Protected X
1
Any Any
SM-I/O 120V X X 3.1 or greater A6 or greater
SM-I/O Lite X
1
Any Any
SM-I/O 32 X X 4.4
2
or greater B3
2
or greater
SM-Applications X
1
Any Any
SM-Applications Lite X
1
Any Any
SM-Applications Plus X
1
Any Any
SM-Profibus DP X X 3.2 or greater A8 or greater
SM-Interbus X
1
Any Any
SM-CAN X
1
Any Any
SM-DeviceNet X X 3.2 or greater A8 or greater
SM-CANopen X
1
Any Any
SM-SERCOS
SM-Ethernet X X 3.1 or greater A6 or greater
SM-SLM

Emerson EZMotion Specifications

General

Brand	Emerson
Model	EZMotion
Category	Control Unit
Language	English