Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics Glossary Index
EZMotion User/Programming Guide 69
Revision A8 www.controltechniques.com
8.3.8 SM-Applications Plus Module View
If Apps/Apps Plus/Apps Lite is selected in the Slot# Module list box, the remainder of the view should be blank. The hierarchy
tree automatically updates to show that an Applications Plus module is populated in the specific slot, see Figure 73.
Figure 73: Slot# View (SM-Applications Plus Module)
8.3.9 SM-Ethernet
If Ethernet is selected in the Slot# Module list box, the remainder of the view should have configuration parameters for the
Ethernet module communications. The hierarchy tree automatically updates to show that an Ethernet module is populated in
the specific slot, see Figure 75.
Figure 74: Slot# View (SM-Ethernet Module)
IP Address
This is a 32-bit identification number for each node on an Internet Protocol network. These addresses are represented as four
8-bit numbers (0 to 255), with periods between them. Each node on the Ethernet network must have a unique IP address. For
To Next Page
Loading...
