122
Reference Manual
00809-0100-4026, Rev HA
Section 6: Operation
November 2014
Operation
Using AMS and DeltaV
The LCD tab in the Configure window specifies which variables will be shown on the Display Panel
screen:
1. Select the transmitter icon in the AMS and DeltaV explorer.
2. Click the right mouse button and choose the Configure option.
3. Select Manual Setup and choose the Display tab to set the desired LCD display
parameters and LCD display measurement units. The available LCD display parameters
are listed in Table 6-1 on page 6-123.
4. Click the Send button to save the configuration.
5. Close the window.
Figure 6-3. Configure Parameters to be Presented on the Display Panel
To Next Page
Loading...
