Endress+Hauser Proline Promass E 300 - Page 112

Commissioning Proline Promass E 300 PROFINET
112 Endress+Hauser
Assign status
→  113
Switch-off value
→  114
Switch-on value
→  114
Failure mode
→  114
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Relay output function – Select the function for the
relay output.
• Closed
• Open
• Diagnostic
behavior
• Limit
• Flow direction
check
• Digital Output
–
Terminal number – Shows the terminal numbers
used by the relay output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
Assign flow direction check In the Relay output function
parameter, the Flow direction
check option is selected.
Select process variable for flow
direction monitoring.
• Off
• Volume flow
• Mass flow
• Corrected volume
flow
*
–