Endress+Hauser Proline Promass E 300 - Performing a Totalizer Reset

Proline Promass E 300 PROFINET Operation
Endress+Hauser 147
Navigation
"Diagnostics" menu → Measured values → Output values → Relay output 1 to n
‣
Relay output 1 to n
Switch status
→  147
Switch cycles
→  147
Max. switch cycles number
→  147
Parameter overview with brief description
Parameter Description User interface
Switch status Shows the current relay switch status. • Open
• Closed
Switch cycles Shows number of all performed switch cycles. Positive integer
Max. switch cycles number Shows the maximal number of guaranteed switch cycles. Positive integer
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using theSetup menu (→  89)
• Advanced settings using theAdvanced setup submenu (→  120)
11.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers
Navigation
"Operation" menu → Totalizer handling
‣
Totalizer handling
Control Totalizer 1 to n
→  148
Preset value 1 to n
→  148
Reset all totalizers
→  148