Endress+Hauser Proline Promass E TB2 HART - Turning the Display Module

Proline Promass E TB2 HART Mounting
Endress+Hauser 23
2.
max.350°
3.
8mm 8mm
1.
A0013713
1. Unscrew the securing screw using an open-ended wrench.
2. Rotate the housing in the desired direction.
3. Firmly tighten the securing screw.
6.2.5 Turning the display module
Esc
–
+
E
1
3mm
1.
2.
3.
4.
A0013905
1. Loosen the securing clamp of the electronics compartment cover using an Allen key.
2. Unscrew cover of the electronics compartment from the transmitter housing.
3. Optional: pull out the display module with a gentle rotation movement.
4.
Rotate the display module into the desired position: Max. 8 ´ 45 ° in each direction.
5. Without display module pulled out:
Allow display module to engage at desired position.
6. With display module pulled out:
Feed the spiral cable into the gap between the housing and main electronics module and plug
the display module into the electronics compartment until it engages.
7. Screw the cover of the electronics compartment firmly back onto the transmitter housing.
8. Tighten the securing clamp again using the Allen key.