Diagnostics and troubleshooting Proline Promass E TB2 HART
84 Endress+Hauser
Ã
The message for the remedial measures for the diagnostics event opens.
2. Press S + O simultaneously.
Ã
The message about the remedial measures closes.
12.3 Diagnostics event in the operating tool
If a diagnostics event is present in the operating tool, the status signal appears in the top left status
area along with the corresponding status symbol in accordance with NAMUR NE 107:
• Failure (F)
• Maintenance required (M)
• Function check (C)
• Out of specification (S)
A0014014-EN
Calling up remedial measures
1. Navigate to the "Diagnostics" menu.
Ã
In the "Actual diagnostics" parameter, the diagnostics event is shown with event text.
2. On the right in the display range, hover the cursor over the "Actual diagnostics" parameter.
Ã
A tool tip with remedial measures for the diagnostics event appears.
12.4 Diagnostic list
In the Diagnose list submenu, up to 5 currently pending diagnostic messages can be displayed. If
more than 5 messages are pending, the messages with the highest priority are shown on the display.
Navigation path
Diagnostics ® Diagnose list
To Next Page
Loading...
