Enerpac JS125 - Page 97

www.enerpac.com
Document number: ED.03783.00.001.ENG rev 4 Page 97 of 153
6.4.2.8 Calibration
To enable Calibration, click on Calibration in the menu bar; then click on Log on.
In calibration mode the main jacks can be extended an retracted to their physical limits.
Hazard
For the JS500, the calibration should be executed without the End Barrel in the
system or with the End Barrel locked by the mini Jacks. When failing to follow
this requirement the system will be damaged and causes potential hazards to
personnel.
Caution
Safety precautions are switched off when Calibration is active.
For calibrating the system follow the instructions given in par 7.5“Calibration”.